BioGuard®
Stain Remover - Removes Stains caused by Metals
BioGuard®
Stain Remover Removes Stains caused by Metals
A specially
formulated blend of 3 concentrated, granular acids, allowing a wide spectrum of
stain removal with one product.
May be used in ALL POOLS treated with chlorine, bromine or biguanide.
Application: Read & follow all label instructions.
Adjust chlorine to less than 1.0 ppm. Pre-dissolve 1.25 lb Stain Remover (for
fresh, mild stains; severe, older stains should increase dosage to 2.0 lb.) per 10,000 gals.
in a plastic bucket of 4 gallons of water. Pour into pool & allow to
circulate for 1 hour. After 1 hour, apply 1 quart of Pool Magnet Plus (use
SoftSwim Stain Control in biguanide pools) per 10,000 gals., & circulate 4
to 8 hours. Apply BioGuard Sparkle Up following the label instructions. Continue
to circulate for 24 hours. Remove Sparkle Up from filter. Test pool
water & readjust water balance. Do not use when chlorine is higher than 1.0 ppm.
DO NOT APPLY SHOCK PRODUCT TO THE POOL WATER FOR 4 DAYS
FOLLOWING TREATMENT.
Product # 122407 1 Quart bottle,
$24.99 each Please see precautionary statement below.
Our Customers Also
Bought...
Chlorines
Shock Treatments
Algicides
Cleaners
Soft Swim
Mineral Springs
Optimizer Plus
NOTE: Avoid physical contact with product. Follow all safety information on label instructions. Open ONLY in WELL VENTILATED AREAS. Avoid breathing fumes. Store in a cool, dry place. Keep out of the reach of children.